M70 Series

Flush Mount High Output Ceiling Microphone

The M70 flush mount condenser microphone is designed for distance miking. Features include a fully integrated preamp, an extremely high sensitivity rating of 38 millivolts, and a small footprint of only 3 inches in diameter. The M70 applications include video conferencing, distance learning, hospital rooms, surveillance, and ambient room miking. The M70 offers a flush mount solution, easy installation, and allows the microphone to completely disappear from view without sacrificing sound quality.

The M70 capsule is housed within a patented cradle that enables the microphone to be aimed and focused up to an angle of 45 degrees towards the sound source. In addition, the M70 has complete immunity from RF interference caused by cell phones and GSM devices.

The M70 ceiling microphone terminates in a terminal block connector and is easy to install, requiring just a 2-inch hole to be drilled with no additional tools.

Designed, assembled, and tested by Audix in the USA.

Note: The M70 comes in stock white and is also available in a satin nickel finish. Dante | AES67 solutions are also available. See below.

Where To Buy M70 Series – Flush Mount High Output Ceiling Microphone
Transducer Type Condenser
Frequency Response 60 Hz – 10 kHz
Polar Pattern Cardioid
Output Impedance 150 ohms
Sensitivity 38 mV / Pa @ 1k
Equivalent Noise Level 22 dB
Signal to Noise Ratio 72 dB
Maximum SPL ≥130 dB
Dynamic Range 108 dB
Power Requirements 18 – 52 V phantom
Connector Terminal Block Connector
Polarity Positive pressure on diaphragm produces positive voltage on pin 2 relative to pin 3 of output XLR connector
Materials / Finish Brass, Aluminum and Steel White or Nickel
Recommended Cable Belden 9451 P or 82761
Length 176 mm / 6.9 in
Download Spec Sheet

1x M70 Ceiling Microphone
1x CONN170F Terminal Block Connector, 1-ft Integrated Microphone Cable
1x CONN170M Mating Terminal Connector
1x JBM55 Metal Plenum Junction Box

  • M70W – Flush mount ceiling cardioid microphone. 12″ cable terminating into phoenix connector. Requires 18 – 52 V phantom power. White.
  • M70N – As above, Nickel.

Capture.Share.

*Manufactured under licence